tel
martino communications
 
 
about the agency
services
experience
client portraits
client list
publications
news
contact
 
 
 

 

 
home > news > details


TPE COMPOUND IS SPECIALLY FORMULATED TO WITHSTAND PUNISHING CONDITIONS OF A GROWING AUTO APPLICATION: BUMPER EXTENSIONS

Volkswagen Touareg

Sarlink® K-156 Elastomer from Teknor Apex Provides Toughness for Scrapes against High Curbs and Moldability for Parts that Are Long or Combine Rigid and Elastic Segments

GELEEN, THE NETHERLANDS, February 16, 2011: A thermoplastic elastomer from Teknor Apex Company is specially formulated for bumper extensions or “spoiler lips,” which are injection molded components that automotive manufacturers increasingly deploy to improve fuel economy.

Installed underneath bumpers or along both sides, the extensions not only help lower the drag coefficient of the car and reduce wind noise during travel but also protect the bumpers from damage encountered when the car is parked near high pedestrian walkways or parking lot curbs. Sarlink® K-156 elastomer provides the balance of stiffness and elasticity required to withstand the punishment of scraping against these structures, according to Ed Deckers, Teknor Apex European business development manager for automotive markets.

“Sarlink K-156 compound is already in commercial use for bumper extensions on selected Renault and Volkswagen models, while for softer solutions we have developed a special high-flow Sarlink range that is in use for certain models at Citroen, Peugeot, and Toyota,” said Mr. Deckers. “These compounds promise to be applied even more widely in bumper extensions as automotive OEMs look for ways to enhance vehicle aerodynamics. At the same time, we expect that the capability of this high-performance elastomer to endure aggressive conditions will lead to other auto applications, including exterior protective strips and mudflaps.”

Mr. Deckers cited the high resistance exhibited by Sarlink K-156 upon prolonged exposure to water spray, road salt, UV, and temperatures as low as –40 ºC.

Formulators of the compound designed it with the high melt strength and good melt flow often required for bumper extensions, which could be up to 1.8 m (nearly 6 ft.) long or include thin-wall segments, noted Mr. Deckers. “Sarlink K-156 provides uniform mold fill and yields a high-quality surface finish. And because this elastomer is compatible with other polyolefins, it forms cohesive melt bonds with rigid polypropylene in multi-material molding. This eliminates an assembly step, reduces weight through parts consolidation, and makes possible full-component recyclability without need for separation.”

Properties of Sarlink K-156 appear on the accompanying table.

PHOTO: Bumper extension injection molded of Sarlink® K-156 TPE is visible on this Volkswagen Touareg as the black component behind the lower bumper lights.

###

SARLINK® thermoplastic elastomers are marketed worldwide by the Thermoplastic Elastomer Division of Teknor Apex Company. The patented Sarlink thermoplastic vulcanizate (TPV) process used by Teknor Apex produces compounds that exhibit outstanding rubber-like properties while being processable at high rates like any other thermoplastic, as well as being recyclable. In comparison with other widely used TPEs, Sarlink TPVs provide superior heat resistance (temperatures up to 135 ºC. / 275 ºF.) and resistance to chemicals, weathering, and abrasion.

The Thermoplastic Elastomer Division of Teknor Apex Company is the most diversified manufacturer of TPEs, offering eight broad product families based on generically distinct chemistries and operating eight TPE plants in the U.S.A., Europe, and Asia. Headquartered in Pawtucket, Rhode Island, U.S.A., the Division is an international supplier to the appliance, automotive, construction, medical-device, wire and cable, and other consumer and industrial product industries. Other plastics businesses of Teknor Apex include the Bioplastics, Nylon, Specialty Compounding, and Vinyl Divisions and Teknor Color Company. Visit www.teknorapex.com.